Repair That Canon Powershot SD Camera Broken Lens Barrier Yourself!
Posted on January 29, 2010
Filed Under Digital Camera Features, Good Digital Cameras |
Many people have asked about repairing their front covers/flaps on their Canon PowerShot SD series cameras, so I’ve written up some instructions. The barrier kit on most Canon PowerShot SD series cameras is a little tricky but not impossible to replace yourself. All you need is some patience, a steady hand and a small tipped screwdriver. We’ve been using dental picks for some time, they do a good job!
To start, you will need to turn on the camera and extend the lens, then open the battery door to turn off the camera and keep the lens out. This allows you to easily work on the lens barrier assembly.
First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Some cameras don’t have one, so if there isn’t one in your kit then your camera doesn’t need it. Make sure it rotates slightly once it has been inserted, otherwise it’s not in properly and can jam the lens.
Next we will install the barrier plates or ‘flaps’ with the springs attached. Put one spring on each of the flaps, there are little tabs to hold them on. They are TINY, they are hard to hold and if you drop it… please take my advice and don’t drop it, ok? We do have just the springs available for purchase, but please try not to lose them.
Carefully put the cover or ‘flap’ in the hole with the spring pointing towards the post where the other end will connect, and then with something with a tiny and pointy tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.
If you do this with the lens covers or ‘flaps’ in the open position they will stay in place once you get them properly seated. If everything pops off, just start again. Do not stretch out the springs as they must remain tight or nothing will work properly.
Then gently put on the barrier cover, it’s a flat plastic ring. There are tabs on the barrier cover, they match up with little slots on the lens and it locks into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.
Now it’s time to test your skills! Put in the battery (cross your fingers) and press the power button! Did it work? Did it go flying across the room with a cute little *SPROING!* and all the parts flew across the room? I hope not, but you’re not alone I’ve been there too.
Once you have it working smoothly …you’re almost done with your first camera repair!
Next put the dual sided tape on the barrier cover. CAUTION: Make sure to take the tape off of the backing paper but DON’T remove the paper that matches the shape of the tape on the other side!! If you take off the small paper part it will ruin the tape because it will fold and stick to itself. Bye bye tape!
The tabs of the tape fold over the edges, if they stick out the lens cover will not fit properly and can jam up the lens. The tape lines up with one tab at about the 11 o’clock position, then fold the tabs over and press them in so they don’t stick out.
Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.
Fire up the camera again and admire your handywork! Congratulations you now know more about Canon camera repair than the Geek Squad, and they told you it would be two hundred dollars and take 3-4 weeks to repair. Whatever Geek Squad… Whatever.
Hmm… I think I’m seeing the beginning of something big here; truely affordable Canon camera repair!
Leave a Reply